In this demo the basics of platter making will be shown, as well as the special considerations for going off center. Safety, of course, will be a primary factor in making this project. By using the 4 jaw chuck as a screw chuck and in the expansion mode, an easy way to make this platter with an uneven rim will be shown. Design considerations will be discussed with the audience, and feedback will be encouraged. This is a fun demo that should spark some new ideas of your own.

In the demo, different possibilities will be discussed, what slight changes will produce in the end result. Difficulties in turning off center will be explained, and how correct technique can minimize these aspects. Also, along the way, how to cut clean beads in a cross grain orientation will be shown, and what details work, and which don’t work as well. Decorating the off center rim will be shown and other possibilities discussed.